The problem is if I set an Outbound NAT from network address 10.0.0.8/32 to go to the wireguard interface, the whole network just stops working to outside of the home NAT. After the package has installed, select VPN then WireGuard and under the Tunnels section, select Add Tunnel. Follow that up through the setup of the Outbound NAT rules, since the rest of the guide funnels all traffic through Mullvad 1. SpookyGhost wrote a very good guide for getting Mullvad connected in pfsense. Open the Package Manager and search for WireGuard, then Install the latest version of the package. Mullvad limits users to 5 wireguard keys, so my combination of devices + connections is limited. I contacted iVPN support and they were happy to tell me their MTU recommendation of 1420 might cause trouble, and I've tried lowering it until 1300, without really getting anything to work.ĭid I miss something when reading the guide or is the latest release 21.1 having some problems with wireguard? One thing I'm considering too would be to just let one IP address from the home network go through the VPN bridge and others could still run from WAN. Follow the instructions below to install the WireGuard package on pfSense. Still, at some point, this needs to be a kernel-mode implementation. Most Linux distributions have supported WireGuard for some time, and OPNsense, as an example, has had userland WireGuard support. What I first thought was the big providers just block VPN cidr spaces, but I was just a week ago still using the same VPN servers with OpenWRT without any trouble with sites. The WireGuard VPN implementation was designed as a kernel-mode solution and then was contributed to FreeBSD. The problem is many of the websites just block me or are very slow. First, fix the default gateway so WireGuard isnt automatically selected before its ready: Navigate to System > Routing Set Default Gateway IPv4 to a specific gateway (e. answers and tells me I'm coming from the VPN IP address. The first big pfSense feature added this week is WireGuard VPN. I can blast a whopping 700-800 Mbit/s with my new router through the VPN. I did follow their guide in and got the connection running. iVPN has been super fast and I've been quite happy with them when I still used OpenWRT. I've finally decided to try to set a VPN client running and routing all traffic using it. My first week as an OPNsense user, and it's been such a pleasure.
0 Comments
Leave a Reply. |